User's Instructions

Aircraft
(ACRO)
Section
– –
56
VTAL On
CH
42
SLV
MAS
4. Press the
Cursor Right
key once, to get to the elevator setting menu. A small arrow is
displayed over the numeral 2, representing elevator master channel, and under the numeral 2,
indicating the right (CH2) ruddervator, and the percent indicator will blink on and off. Move
the elevator stick all the way to the back (full up position): both ruddervators should move
upwards. If the right (CH2) ruddervator moves down, change the its travel direction by
pressing the
Active/Inhibit (Clear)
key, then pressing the
Data –Decrease
key until you reach -
50%.
CH
N
R
42
SLV
MAS
5. If the left (CH4) ruddervator moves down with up elevator stick, change the its travel
direction by pressing the
Cursor Right
key (the bottom arrow moves under the 4), the
Active/Inhibit (Clear)
key (sets 0%), then press the
Data –Decrease
key until you reach -50%.
Otherwise, continue.
CH
N
R
42
SLV
MAS
6. Now you’ll input the amount of rudder stick response on the left (CH4) ruddervator by
pressing the
Cursor Right
key once. Now the little arrows move both over and under the 4,
and you may adjust the amount of left ruddervator travel with the
Data +Increase
and
–
Decrease
keys. 50% is a good starting point. Press
Active/Inhibit (Clear)
key if you wish to
reset to 0%).
CH
N
R
42
SLV
MAS
7. Now you’ll input the amount of rudder stick response on the right (CH2) ruddervator by
pressing the
Cursor Right
key once. Now the little arrow moves under the 2, and you may
adjust the amount of right ruddervator travel with the
Data +Increase
and
–Decrease
keys.
50% is a good starting point. Press
Active/Inhibit (Clear)
key if you wish to reset to 0%).
CH
N
R
42
SLV
MAS
8. Remember to be sure not to have so much travel as to cause binding when both elevator and
rudder are commanded simultaneously.