User's Instructions

Aircraft
(ACRO)
Section
– –
48
mixers such as flaperon, be sure to set correct travels in the REV menu setting up the
preprogrammed function.
Reversing Servos
1. Get to the
REV
screen with the
Edit Up Down
keys.
2. Use the
Data +Increase
or
–Decrease
key to select the channel you wish to reverse. The
active channel number will flash.
REV
CH
421 3 567
N
R
3. Toggle between normal (
N
) and reverse (
R
) with the
Active/Inhibit (Clear)
key. The arrow
above the number indicates normal travel, while the arrow below indicates reversed travel
(the figure shows all channels normal, none reversed).
4. Repeat this procedure for each channel needing to be reversed.
5. Return to the regular operating mode by pressing the two
Edit Up Down
keys simultaneously.
T.CUT
— Throttle Cut (Engine Kill) Function
The Throttle Cut function provides you an easy way to stop the engine by simply
pressing a button with the throttle stick at idle, which commands the throttle servo to move a
prescribed amount. The throttle servo moves to the selected cut position when the Cut button is
pressed and the throttle stick is below 50%. Above 50% throttle, the cut button has no effect.
The activation direction may be chosen by the owner.
Setting up the Throttle Cut function
1. Get to the
T.CUT
screen with the
Edit Up Down
keys.
2. Place the throttle at its idle position (towards bottom of transmitter). Use the
Data –Decrease
key to select the amount of motion of the throttle servo you wish — normally you want to
completely close the carburetor, but be careful not to choose too much travel which will stall
the servo. You may see the servo move when you press the
Active/Inhibit (Clear)
button. A
maximum of 72% may be chosen, but only use the amount you need to fully close the
carburetor without stalling the servo.(Picture : Need !over 3)
T.CUT -14
CH
%
3
flashing
3. Return to the regular operating mode by pressing the two
Edit Up Down
keys simultaneously.