User's Manual

33
6. Timers and lap counters ºº 0000
The PROFI CAR (403 and 707) offers the following facilities for timing and lap
counting:
v Operating time
This timer can be reset to zero in the „T “ menu. It is used to record the
operating time of the transmitter battery or the transmitter itself. This timer
always runs when the transmitter is switched on.
v Nominal lap time
For practising you can set a „nominal time“ (target time) for a single lap. The
transmitter gives an audible signal to let you know whether you were faster
or slower than the set time.
v Race duration
You can enter the race duration in the form of a number of laps or a set time.
The transmitter alerts you to the start of the last lap with an audible signal.
v Memory for 50 lap times
Once you have selected the appropriate operating mode (timer mode), you
can „stop“ lap times with the handle button
G
. The transmitter’s memory
can store up to 50 lap times, and the times are retained even when you
switch off the transmitter or replace the battery.
v Total race time
A special memory (on-screen symbol „–“) is available as a stopwatch for the
entire race.
You can select the following menu points using the U button:
TT --MODEMODE
Timer mode 6.1
OPTIMEOPTIME
Check transmitter operating time 6.5
ERASEERASE
Erase lap counter, time memory, nominal time,
race duration (time and lap count) and operating time
6.6
TIMESTIMES
Check lap time memory 6.2
TT --NOMNOM
Enter the nominal time for a lap 6.3
DURADURA
Enter the race duration as a time or No. of laps 6.4
6.1. Timer mode
There are three different modes of operation for the timer. The fourth possible mode
is to switch off the timer functions entirely (T-MODE: OFF).
Mode Effect
OFFOFF
All timer functions switched off
LAPSLAPS
Lap counter active
L+TL+T
Lap counter + lap time memory active
L+T+DL+T+D
Lap counter + lap times + race duration