User's Manual
29
This is the procedure:
A
BRABRAKE1KE1
Search for menu
point
Search for point on
brake curve
Example:
Engage point 27%
BRAKE1
EP 27
%
Set value
IDL Idle -50% to +50%
EP Engage point OFF or
1 – 100%
LP Lock Pint 0 – 100%
EXP EXPO ± 100%
!!
If you are using a combined throttle/brake servo (all vehicle types except „5 CH“),
the idle point „IDL“ exists on the throttle curve as well as the brake curve
5.2. Trimming the Lock Point LP using rocker D
The lock point of the brake normally changes
during a race, so it is helpful to be able to
compensate for that change. This is done by means
of trim rocker D. Rocker D affects the lock point of
the THROTTLE/BRAKE servo (servo 2) or servo 3 (first
brake servo) of the vehicle types 3+1 CH and 5 CH.
The brake trim allows you to adjust the lock point by
7 increments in each direction. Each increment
offsets the lock point by at least 1% (fine) and at
most 10% (coarse). You can select the size of the
trim increments in the menu point „STEP“ of the „T“ menu.
The default setting is 2%.