OPERATION MANUAL Ver 1.0 www.hitecrcd.
TABLE OF CONTENTS Section 1 Introduction.............................................................................................................................................................. 2 Warnings and Safety Instructions..................................................................................................................... 3 Features and Specifications................................................................................................................................
Flying Your Aircraft • • • • • • • • • • • • You should only fly at an official model airfield. Check that other pilots and spectators are positioned safely before flying your model. Wait for other pilots to land their models if they are flying already. Do not fly the plane behind yourself or others. Do not fly under the influence of alcohol or drugs or if you are feeling ill. Do not fly during thunderstorms or high wind. Do not fly in an area where people are gathered or near tall buildings.
PARTS LAYOUT AND LISTING Note: Before assembly, it is important that you remove the parts from the packaging and check to make sure that all the parts are included and that they are in good condition. A. Fuselage Assembly (includes installed Motor, ESC and Elevator Servo) B. Main Wing C. Horizontal Stabilizer D. 2x Spinner E. Small Parts Package, Includes: i. Propeller ii. 1 piece 2.0 x 16mm screw for wing iii. 1 piece double sided tape for mounting receiver iv.
Step 2 Step 2: Main Wing Assembly Install the wing by sliding the tab on the front of the wing into the fuselage while guiding the servo leads through the hole. Insert the 2.0 x 16mm screw and tighten until snug. Step 3 While not necessary, you can apply a small amount of CA glue to hold the pieces permanently in place. Step 3: Spinner Assembly Place the foam spinner over the propeller.
Step 6: Balancing Your Model Check the center of gravity (CG) on your model by balancing it on your fingers.The CG should be at about the same place as the servo leads on the bottom of the wing. You can adjust the CG by moving the battery forward or backwards. Step 6 CG SECTION 3 PREPARING FOR FLIGHT Speed Control Operation The ESC is set for optimal performance at the factory and should not be changed. Before connecting the battery, make sure the throttle is in the lowest (off ) position.
SERVICE AND SUPPORT Weekender by Hitec Customer Service Help is available from Hitec RCD USA, Inc. Customer Service through phone support: (858) 748-6948 and e-mail: service@hitecrcd.com. Our office is generally open Monday through Friday, 8:00 AM to 4:30 PM PST. These hours and days may vary by season. Every attempt is made to answer all incoming service calls. Should you get our voice mail, please leave your name and number and a staff member will return your call.
