User Manual

1514
Battery Connections
TO AVOID SHORT CIRCUITS, ALWAYS CONNECT THE CHARGE LEADS
TO THE CHARGER FIRST, AND THEN TO THE BATTERY. REVERSE THE
SEQUENCE WHEN DISCONNECTING THE PACK.
Warning
Lithium Battery Connection With
Balance Adaptor
Battery Connection for
NiMH/NiCD and PB Batteries
2S 3S 4S 5S
6S
1
2
3
4
5
6
BATTERY
DC 11-18V
BALANCE
SOCKET
BALANCE ADAPTOR
X1 CHARGER
BALANCE
LEAD
Available Operations
Depending on the battery type, di erent operations will be available. The
chart on the following page shows which operations are available for the
di erent types of batteries the X4 AC Pro is capable of working with.
Getting Started
Initial Setup of the Charger
After connecting the battery, you are now ready to set up the charger to
charge your speci c type of battery. When the charger is  rst powered
on, it will start at Channel A. The default mode of the charger is for a
regular charge mode of a 2 Cell (7.4V) 2000 mAh Lithium Polymer battery.
If this is not the battery you plan on working with, then you will need to
make changes to the operation programming based on the following
instruction.
BEFORE SELECTING AN OPERATION, IT IS CRITICAL THAT YOU
KNOW THE TYPE OF BATTERY YOU ARE WORKING WITH AND WHAT
THE MANUFACTURER RECOMMENDATIONS ARE FOR CHARGING OR
DISCHARGING. FAILURE TO FOLLOW THE MANUFACTURERS REC
OMMENDATIONS CAN RESULT IN DAMAGE TO THE BATTERY AND
POSSIBLE EXPLOSION.
Warning
Batt. Type/Stop Button
Start/Enter Button
Start the progress of the
current action or cycle into
the next step/screen
Scroll through available menus
or increase parameter values.
Scroll through available menus
or decrease parameter values.
Stop the progress of
the current action
or cycle back to the
previous step/screen.
INC. Button
DEC. Button
Input Buttons
Balance Socket
For safety reasons, the default setting for charging Lithium (LiPo, Lilon, LiFe
and LiHV)batteries is using a balancing connector to connect the battery
and charger in Charge, Fast Charge, Balance Charge and Storage modes. If
your battery does not have a balance adaptor without a balance wire con-
nector, you must disable this function in the system settings as follows.
The balance wire attached to the battery must be connected to the charger
with the black wire aligned with the negative marking. Ensure correct polarity!
Channel Select
Button
NiMH
ON
BAL. Connection
SYTEM SETTINGS
BATT / PROGRAM