User Manual

15
BATTERY TYPE OPERATION OPERATION DESCRIPTION
LiPo,
LiFe,
Li-ion
Charge The charge mode is for charging LiPo/LiFe/LiIon/ LiHV batter-
ies in normal mode.
Discharge This mode is for discharging LiPo/LiFe/LiIon batteries.
Storage
This program is for charging or discharging a lithium battery
which will not be used again for an extended period of time.
Fast Charge A fast charge will result in a smaller than usual charging ca-
pacity but will reduce the total charge time.
Balance This mode is for balancing the voltage of
LiPo battery cells while charging.
NiMH,
NiCD
Charge The charger will charge NiMH and NiCd batteries using the
charge current set by the user.
Auto Charge
In this program, the charger detects the condition of the con-
nected battery and automatically charges the battery.
NOTE: You should set the upper limit of the charge current to
avoid damage by excessive charging current. The Power Peak
D7 may not be able to detect the charge capacity of low resis-
tance batteries.
Discharge This mode is for discharging a NiMH/NiCd battery.
Re-Peak In re-peak charge mode, the charger can peak charge the bat-
tery once, twice, or three times in a row automatically. This is
good for conrming the battery is fully charged and for check-
ing how well the battery receives fast charges.
Cycle Automatically charges/discharges the battery up to 5 times.
This process can enhance the performance of
NiMH/NiCd batteries.
Pb
(Lead Acid)
Charge This mode is for charging a Pb battery using the charge current
set by the user.
Charge This mode is for discharging a Pb battery using the charge current set
by the user.
Press and hold the START/ENT button until the charge selection screen is displayed like one of the
examples shown below and on following page.
[ 01 ] Memory Name...
LiPo 7.4 V 200mAh
Charge :
Discharge :
Storage :
Fast Charge :
Balance :
[ 02 ] Memory Name...
NiMH 4Cell 2100mAh
Charge :
Auto Chg :
Discharge :
Repeak :
Cycle :
Lithium Battery Process Screen NiMH/NiCd Process Screen