Manual

Your camera/recorder is a highly sophisticated instrument. It has been carefully
checked and adjusted at the factory under the most rigid quality control and inspection
systems. However, should problems develop, check the following points and take the
necessary corrective measures.
INSERTING OR REMOVING THE CASSETTE
Symptom
Cassette holder cannot be opened
when you slide "EJECT" button
Cassette cannot be inserted into
cassette compartment.
Check Point & Correction
Connect the power source.
Load cassette in direction indicated by
arrow on cassette.
Cassette window must be toward
outside.
SYMPTOM
Picture does not appear in the
viewfinder.
CAMERA RECORDING
CHECK POINT & CORRECTION
Remove the lens cap.
The camera/recorder cannot go into
the recording mode, even when record
start/stop button is pressed.
Set "POWER" switch to "CAM".
The cassette has had the erase
prevention tab removed. Stick a piece
of cellophane tape over the erase
prevention hole or select a different
cassette.
Set "POWER" switch to "CAM"
position.
The camera/recorder is set to MACRO
mode. Release the MACRO mode, and
then focus on the object.
Picture is out of focus.
Auto-focus does not operate. Auto-focus does not operate if the wide
angle or telephone lens is attached.
BATTERY CONDITION
Symptom Check Point & Correction
The "_" indication in the electronic Try another battery or charge the
viewfinder battery.
I NO OPERATION IS ACCEPTED 1
Symptom Check Point & Correction
Power is not turned on an no button Remove the power source, and after
operations are accepted, about one minute, push the reset
6!