Technical Information
Piping work and
refrigerant charge
TCGB0079 rev.0 - 01/2013
120
9.3.2 Pipe connection
Fix the connecting pipe as shown in the gure below. Use the insulation attached to the indoor unit.
A. Use the are nut of the indoor unit.
B. Insulate this part with the insulation material supplied.
C. Fix this part with the bracket supplied or with tape.
D. Refrigerant piping in the installation.
E. Field-supplied insulation.
F. Brazing.
G. Make ares after attaching are nut to the connecting pipe in
the Multikit package.
H. Insulation attached to indoor unit.
I. Indoor unit.
N O T E
• Asystemwithnomoistureoroilcontaminationwillgivemaximumperformanceandlife-cycleascomparedwithapoorly
preparedsystem.Takeparticularcaretoensurethatallcopperpipingiscleananddryinternally.
• Toensurethis,blowoxygenfreenitrogenthroughthepipes.
C A U T I O N
• Captheendofthepipewhenthepipeistobeinsertedthroughahole.
• Donotplacepipesdirectlyonthegroundwithoutacaporvinyltapecoveringtheend,asitshowninthegure.
Right Wrong
• Ifpipinginstallationcannotbecompleteduntilthefollowingdayorlonger,soldertheendsofthepipingto
closethemand loadwithoxygen-free nitrogenusingan accessdevicesuchasaSchrader valvetoavoid
moistureandcontaminationbyextraneousparticles.
• Do notuse insulation material containingNH3 as it candamage the copper pipingmaterial and may bea
sourceoffutureleakage.
9.3.3 Insulation
Attach insulation package with the Multikit to each branch using vinyl tape. Also attach insulation to eld-supplied piping to
prevent capacity decrease due to ambient air conditions and dewing on pipe surface caused by low pressure.
N O T E
• Whenpolyethylenefoamisapplied,athicknessof10mmfortheliquidpipingandfrom15mmto20mmforthegas
pipingisrecommended.
C A U T I O N
Performinsulationworkafterthesurfacetemperaturedecreasestotheroomtemperature,Ifnot,theinsulationmaterial
maymelt.Iftheendsofthepipingsystemareopenafternishingtheinstallationwork,securelyattachcapsorvinylbags
totheendsofthepipingtopreventmoistureordustentering.
TCGB0079_rev0_11-2012.indb 120 29/01/2013 14:27:31










