Service Manual

10. Servicing
400
SMGB0079 rev.0 - 01/2013
11 Perform in the reverse procedure of removing after replacing the compressor.
a. Check if the Faston terminal has any abnormality. (Ensure the pull out force greater than 20 Nm). If the Faston
terminal is identied faulty replace with a new one.
b. Ensure the xture of the lead wires.
c. Surely x the terminal box by tightening the closing nut (Tightening Torque: 3.0 Nm).
d. Attach the top of sound-proof cover to cover surely the compressor.
e. Wrap the sound-proof cover to cover the terminal box and the discharge pipe.
f. Attach the crankcase heater without torsion and gap to the compressor as following gure.
Sound-Proof Cover
Closing Nut
(Tightening Torque: 3 ~ 4N-m)
Thermal Box
Thermal Box
Discharge Pipe
Compressor
2
3
1
Sound-Proof Cover
Surely cover it.
Boss Hole
Foot
Bolt
Fixing Plate
Attachment of Terminal Box
Surely cover it
Closing Nut
(Tightening torque: 3~4 Nm)
Sound-proof Cover
Therminal box
Discharge pipe
Sound-proof Cover
Attachment of Terminal box
Therminal box
Fixing plate
Boss hole
Bolt
Foot
Compressor
Crankcase Heater Compressor
When attatching the spring,
pay attention not to damage
the crankcase heater.
Detail of Spring for Crankcase Heater
Detail of Spring for Cranckase Heater
Cranckase Heater
Compressor
When attaching the spring,
pay attentio not to damage
the cranckase heater.