Instruction Manual
Table Of Contents
- 1 Safety summary
- 2 Switch Names and Functions
- 3 Operation
- 4 Icon Description
- 5 Function Menu
- 5.1 Simple Timer Setting
- 5.2 Operation Schedule Setting
- 5.3 Power Savings Setting
- 5.4 Night Quiet Operation
- 5.5 Power Saving/Night Quiet Schedule Setting
- 5.6 Power Consumption Display
- 5.7 Autoboost (QUICK MODE) Setting
- 5.8 Comfort Setting
- 5.9 Motion sensor setting
- 5.10 Setback Setting
- 5.11 Elevating Grille
- 5.12 Filter Reminder Reset Setting
- 5.13 FrostWash
- 5.14 Individual Louver Setting
- 5.15 Cancel Individual Louver Setting
- 5.16 Louver Open/Close
- 5.17 Ventilation
- 5.18 Total Heat Exchanger Setting
- 6 Service & installation menu
- 6.1 Installation menu
- 6.1.1 Test Run
- 6.1.2 Function selection
- 6.1.3 Thermistor Selection
- 6.1.4 Input / Output Setting
- 6.1.5 Thermistor Calibration in Controller
- 6.1.6 Fan Speed at Cooling Thermo-OFF
- 6.1.7 Fan Speed at Heating Thermo-OFF
- 6.1.8 Indoor Unit Address Change
- 6.1.9 Address Check Operation
- 6.1.10 Address Initialization
- 6.1.11 Setting Initialization
- 6.1.12 Main Remote Setting
- 6.1.13 Priority Setting
- 6.1.14 Cancel Preheating Control
- 6.1.15 Elevating grille Setting
- 6.1.16 Power Up Setting
- 6.1.17 Setback Trigger Unit
- 6.1.18 Refrigerant Leak Sensor Setting
- 6.2 Service menu
- 6.3 Check Menu
- 6.1 Installation menu
- 7 Screen Display Setting menu
- 8 Contact Information menu
- 9 Hotel Mode Setting
- 10 In Alarm Condition
Continue from previous page
➪
Electronic Expansion Valve
30 IDU Electronic Expansion Valve (%) L1 20
➪
31 ODU Electronic Expansion Valve (%) L2 99
➪
32 ODU Electronic Expansion Valve 2 (%) L3 99 For exible multi-type, the value of Unit A is indicated.
➪
33 ODU Electronic Expansion Valve B (%) L4 00
➪
Compressor status (reference)
➪
The total value is displayed if multiple compressors are operating.
Primary (input) current is displayed for inverter compressor.
34 Compressor Current (A) P1 20
➪
35 Compressor Time P2 00000 Possible longest time is shown for multi-type units.
Sensor Status Display
36 Motion Detector Sensitivity (%) q1 00
➪
37 Radiant temp. sensor (ºC) q2 00
➪
38 Motion Detector 1 Sensitivity (%) q3 00
➪
39 Motion Detector 2 Sensitivity (%) q4 00
➪
40 Motion Detector 3 Sensitivity (%) q5 00
➪
41 Motion Detector 3 Sensitivity (%) q6 00
➪
42 Setting Temp. Collected value (ºC) q7 00
➪
Continue to next page
EN
SERVICE & INSTALLATION MENU
PMML0565 rev.1 - 04/202285