Instruction Manual

6.2.8 Room Name Setting
Register the installation location of the controller.
1 Select “Service Menu” on the “Service & Installation” screen
and press “OK”.
2 Select “Set Room Name” and press “OK”.
3 Press “
” to move cursor to font type. Press “ ” or “ ” to
select the font type. Each time you want to change the font
type, move cursor to the rst character on the st line at the
upper left corner of the screen, then press “ ” to select the
font type.
4 Press “
” to move the cursor to the font area. Press” ”, “ ”,
“ ”, or “ ” to select the font and press “OK” to register it (up to
32 characters can be registered).
5 After registration, select “
Fin
” and press “OK”.
6 The conrmation screen is displayed. Select “Yes” and press
“OK” to conrm the settings and Step2 is displayed.
If “No” is selected, the screen returns to Step3.
Font type
Font area
6.2.9 Contact Information Registration
Register a service contact (service address and service
telephone number are recommended).
1 Select “Service Menu” on the “Service & Installation” screen
and press “OK”.
2 Select “Set Contact Information” and press “OK”.
3 “Contact Information1” screen is displayed. Press “
” to move
cursor to font type. Press “ ” or “ ” to select the font type.
Each time you want to change the font type, move cursor to
the rst character on the st line at the upper left corner of
the screen, then press “ ” to select the font type.
4 Press “
” to move cursor to the font area. Press” ”, “ ”, “ ”,
or “ ” to select the font and press “OK” to register it (up to
60 characters can be registered).
5 After registration, select “
Fin
” and press “OK”.
6 “Contact Information2” screen is displayed, repeat Step3,
Step4 and Step5.
7 Select “Yes” and press “OK” to conrm the setting and Step2
is displayed.
If “No” is selected , the screen returns to Step3.
EN
SERVICE & INSTALLATION MENU
PMML0565 rev.1 - 04/202279