Instruction Manual
Table Of Contents
- 1 Safety summary
- 2 Switch Names and Functions
- 3 Operation
- 4 Icon Description
- 5 Function Menu
- 5.1 Simple Timer Setting
- 5.2 Operation Schedule Setting
- 5.3 Power Savings Setting
- 5.4 Night Quiet Operation
- 5.5 Power Saving/Night Quiet Schedule Setting
- 5.6 Power Consumption Display
- 5.7 Autoboost (QUICK MODE) Setting
- 5.8 Comfort Setting
- 5.9 Motion sensor setting
- 5.10 Setback Setting
- 5.11 Elevating Grille
- 5.12 Filter Reminder Reset Setting
- 5.13 FrostWash
- 5.14 Individual Louver Setting
- 5.15 Cancel Individual Louver Setting
- 5.16 Louver Open/Close
- 5.17 Ventilation
- 5.18 Total Heat Exchanger Setting
- 6 Service & installation menu
- 6.1 Installation menu
- 6.1.1 Test Run
- 6.1.2 Function selection
- 6.1.3 Thermistor Selection
- 6.1.4 Input / Output Setting
- 6.1.5 Thermistor Calibration in Controller
- 6.1.6 Fan Speed at Cooling Thermo-OFF
- 6.1.7 Fan Speed at Heating Thermo-OFF
- 6.1.8 Indoor Unit Address Change
- 6.1.9 Address Check Operation
- 6.1.10 Address Initialization
- 6.1.11 Setting Initialization
- 6.1.12 Main Remote Setting
- 6.1.13 Priority Setting
- 6.1.14 Cancel Preheating Control
- 6.1.15 Elevating grille Setting
- 6.1.16 Power Up Setting
- 6.1.17 Setback Trigger Unit
- 6.1.18 Refrigerant Leak Sensor Setting
- 6.2 Service menu
- 6.3 Check Menu
- 6.1 Installation menu
- 7 Screen Display Setting menu
- 8 Contact Information menu
- 9 Hotel Mode Setting
- 10 In Alarm Condition
Check 1
1 Select “Check 1” on the “Refrigerant Leak Sensor Setting”
menu and press “OK”.
2 Press “ ”, “ ”, “ ”, or “ ” to select the indoor unit. Press “OK”.
If there is only one indoor unit connected to the wired remote
controller, this screen is not displayed (the screen in Step 3
is shown).
3 Press “ ” or “ ” to change the page of check data.
By pressing and holding “ ” for 3 seconds or longer, the
items are displayed with a description, translated in the
selected language. The text displayed is for reference. Refer
to the technical resource for each indoor unit for details.
4 Press “OK” to get pass the information screen.
5 A list of items will be displayed with the corresponding item
description and its value. Short press “ ” to browse through
the items. By pressing “ ” once, the display returns to the
rst items list screen. By pressing “ ” again the display
returns back to the “Check 1” screen.
SERVICE & INSTALLATION MENU
PMML0565 rev.1 - 04/202272