Instruction Manual
Table Of Contents
- 1 Safety summary
- 2 Switch Names and Functions
- 3 Operation
- 4 Icon Description
- 5 Function Menu
- 5.1 Simple Timer Setting
- 5.2 Operation Schedule Setting
- 5.3 Power Savings Setting
- 5.4 Night Quiet Operation
- 5.5 Power Saving/Night Quiet Schedule Setting
- 5.6 Power Consumption Display
- 5.7 Autoboost (QUICK MODE) Setting
- 5.8 Comfort Setting
- 5.9 Motion sensor setting
- 5.10 Setback Setting
- 5.11 Elevating Grille
- 5.12 Filter Reminder Reset Setting
- 5.13 FrostWash
- 5.14 Individual Louver Setting
- 5.15 Cancel Individual Louver Setting
- 5.16 Louver Open/Close
- 5.17 Ventilation
- 5.18 Total Heat Exchanger Setting
- 6 Service & installation menu
- 6.1 Installation menu
- 6.1.1 Test Run
- 6.1.2 Function selection
- 6.1.3 Thermistor Selection
- 6.1.4 Input / Output Setting
- 6.1.5 Thermistor Calibration in Controller
- 6.1.6 Fan Speed at Cooling Thermo-OFF
- 6.1.7 Fan Speed at Heating Thermo-OFF
- 6.1.8 Indoor Unit Address Change
- 6.1.9 Address Check Operation
- 6.1.10 Address Initialization
- 6.1.11 Setting Initialization
- 6.1.12 Main Remote Setting
- 6.1.13 Priority Setting
- 6.1.14 Cancel Preheating Control
- 6.1.15 Elevating grille Setting
- 6.1.16 Power Up Setting
- 6.1.17 Setback Trigger Unit
- 6.1.18 Refrigerant Leak Sensor Setting
- 6.2 Service menu
- 6.3 Check Menu
- 6.1 Installation menu
- 7 Screen Display Setting menu
- 8 Contact Information menu
- 9 Hotel Mode Setting
- 10 In Alarm Condition
6.1.4 Input / Output Setting
1 Select “Installation Menu” on the Service & Installation
screen and press “OK”.
2 Select “Input/Output” setting and press “OK”.
3 Select the indoor unit by pressing “ ”, “ ”, “ ”, or “ ” and
press “OK”.
This screen is NOT displayed when only one indoor unit
is connected with the controller. In this case, “Step4” is
displayed.
Indoor unit number
(Refrigerant system number - Indoor unit Address
4 Press “ ” or “ ” to select the item.
5 Press “
” or “ ” to change the setting.
6 Press “OK” and the conrmation screen is displayed.
7 Select “Yes” and press “OK” to conrm the setting and the
screen returns to Step2.
If “Cancel” is selected, the setting is cancelled and the
screen returns to Step2.
If there is more than one indoor units connected to the
remote controller, the screen returns to Step3.
Press “
” to return to Step4.
EN
SERVICE & INSTALLATION MENU
PMML0565 rev.1 - 04/202259