Instruction Manual

Element Optional function
Individual
setting
Settings Setting conditions Description
r2
Setting of temperature
differential for switching
cooling and heating
X
0.5 0.5°C
This function can only be set
when function r1 is set to 01.
1.0 1.0°C
1.5 1.5°C
2.0 2.0°C
2.5 2.5°C
3.0 3.0°C
r3 Not used -
0.5
- Not used
1.0
1.5
2.0
2.5
3.0
3.5
4.0
4.5
5.0
5.5
r4 Not used -
00
- Use at 00 conditions
01
r5 Not used -
00
- Use at 00 conditions
01
r6 FrostWash Manual Setting X
00 Allow To enable / disable the manual
setting of the FrostWash
function.
01 Prohibit
r7 FrostWash Automatic Setting X
00 Allow
To enable / disable the
automatic setting of the
FrostWash function.
01 Prohibit
r8
Enable/Disable Auto-
FrostWash
X
00 Disable
To enable / disable FrostWash
function.
01 Enable
r9
Remote control prohibition
during setback operation
X
00 Start/Stop allowed (Factory setting)
Manual run/stop from the
remote controller can be
disabled during setback
operation.
This function is xed to 00
(Disabled) when function qE is
set to 00 (Always).
01
Start/Stop not allowed
! DANGER
Blocking of Start/Stop shall never be set
due to safety concerns.
02 Only Stop allowed
rA FrostWash Intervals Setting X
00 100h
This function is used to
dene the intervals between
FrostWash operation.
01 200h
02 400h
03 50h
rb
Minimum operation time to
allow the change of operation
mode in auto cooling/heating
mode with dual set point
X
00 Disabled
This function is used to dene
a minimum time of operation
in a given mode, in order to
avoid too frequent changes of
operation mode.
Operation mode does not
change until the minimum
transition time passes, even if
the room temperature reaches
the setpoint to shift to the other
operation mode.
01 10 minutes
02 20 minutes
03 30 minutes
04 40 minutes
05 50 minutes
06 60 minutes
07 70 minutes
08 80 minutes
09 90 minutes
10 100 minutes
11 110 minutes
12 120 minutes
EN
SERVICE & INSTALLATION MENU
PMML0565 rev.1 - 04/202255