Instruction Manual

Element Optional function
Individual
setting
Settings Setting conditions Description
K9 Not used -
00
- Use at 00 conditions
01
KA Not used -
00
- Use at 00 conditions
01
L1
Setting Position of Motion
Sensor
○
00 A
-
01 B
02 -
03 D
L2 Not used -
00
- Use at 00 conditions
01
02
03
L3
Operation of the louvers in
energy-saving Thermo-OFF
(Cooling / Dry mode)
O
00 Direct air blow Low (factory setting)
Power save must be ON in
order to use this function (L5
must be set to 01).
This function is used to establish
louver swinging operation
ranging from continuous swing
to static operation.
Low: Continuous louver swing.
Medium: Louver swing
with intermittent stops for
20/40 seconds.
High: Louver stopped at full
opening position, according to
the setting of CF.
01 Direct air blow Medium
02 Direct air blow High
03 Disabled
L4
Fan acceleration in energy-
saving Thermo-OFF (cooling
mode)
O
00 Function disabled (factory setting)
This function increases fan
speed by one step to prevent
the loss of comfort due to the
forced Thermo- OFF for energy
saving during cooling operation.
01 Function enabled
L5
Louver swing operation
during energy-saving forced
Thermo-OFF
O
00 Function disabled (factory setting)
This function is used to enabled
the setting of function L3.
01 Function enabled
L6 Not used -
00
- Use at 00 conditions
01
L7 Not available –
“- -”
permanent
– –
L8 Not used -
00
- Use at 00 conditions
01
L9 Not used -
00
- Use at 00 conditions
01
LA Not used -
00
- Use at 00 conditions
01
Lb Not used -
00
- Use at 00 conditions
01
SERVICE & INSTALLATION MENU
PMML0565 rev.1 - 04/202252