Instruction Manual

4 Press “ ”, “ ”, “ ”, or “ ” to select the indoor unit to be set
and press “OK”.
This screen is not displayed when only one indoor unit is
connected to the wired remote controller (the screen in Step
5 is shown).
Indoor unit number
(Refrigerant system number - Indoor unit address number)
5 Press “ ” or “ ” to select the type tab and press “OK”.
→It changes in the order of “b-J” ↔ “K-P” ↔ “q-S” ↔ “ ”.
Type tab
List area
6 Press “ ”, “ ”, “ ”, or “ ” to select the item to set from the list
area. Press “ ” and press “ ” or “ ” to change the setting
value.
After selecting the setting value, press “ ” to return to the
setting item selection mode.
To return to Step 5, press “ ” in the setting item selection
mode.
7 To conrm the setting, press “
” in the tab selection mode.
8 Select “Yes” and press”OK” to conrm the setting and return
to Step 2.
Select “No” and press”OK” to discard the settings and return
to Step 2.
Press “
”to return to Step 5.
SERVICE & INSTALLATION MENU
PMML0565 rev.1 - 04/202240