Instruction Manual
Table Of Contents
- 1 Safety summary
- 2 Switch Names and Functions
- 3 Operation
- 4 Icon Description
- 5 Function Menu
- 5.1 Simple Timer Setting
- 5.2 Operation Schedule Setting
- 5.3 Power Savings Setting
- 5.4 Night Quiet Operation
- 5.5 Power Saving/Night Quiet Schedule Setting
- 5.6 Power Consumption Display
- 5.7 Autoboost (QUICK MODE) Setting
- 5.8 Comfort Setting
- 5.9 Motion sensor setting
- 5.10 Setback Setting
- 5.11 Elevating Grille
- 5.12 Filter Reminder Reset Setting
- 5.13 FrostWash
- 5.14 Individual Louver Setting
- 5.15 Cancel Individual Louver Setting
- 5.16 Louver Open/Close
- 5.17 Ventilation
- 5.18 Total Heat Exchanger Setting
- 6 Service & installation menu
- 6.1 Installation menu
- 6.1.1 Test Run
- 6.1.2 Function selection
- 6.1.3 Thermistor Selection
- 6.1.4 Input / Output Setting
- 6.1.5 Thermistor Calibration in Controller
- 6.1.6 Fan Speed at Cooling Thermo-OFF
- 6.1.7 Fan Speed at Heating Thermo-OFF
- 6.1.8 Indoor Unit Address Change
- 6.1.9 Address Check Operation
- 6.1.10 Address Initialization
- 6.1.11 Setting Initialization
- 6.1.12 Main Remote Setting
- 6.1.13 Priority Setting
- 6.1.14 Cancel Preheating Control
- 6.1.15 Elevating grille Setting
- 6.1.16 Power Up Setting
- 6.1.17 Setback Trigger Unit
- 6.1.18 Refrigerant Leak Sensor Setting
- 6.2 Service menu
- 6.3 Check Menu
- 6.1 Installation menu
- 7 Screen Display Setting menu
- 8 Contact Information menu
- 9 Hotel Mode Setting
- 10 In Alarm Condition
5.15 CANCEL INDIVIDUAL LOUVER SETTING
1 Select “Individual Louver Setting” on the “Function Menu”
and press “OK”.
2 Select “Cancel Individual Louver Setting” and press “OK”.
? NOTE
If there is one indoor unit connected with the controller, Step4 is displayed.
3 Press” ”, “ ”, “ ”, or “ ” to select the indoor unit to cancel the
louver direction, and press “OK”.
? NOTE
The indoor unit displayed on the screen ashes if an individual louver is
set.
4 Press “ ” or “ ” to select “Yes” and press “OK”. Cancel the
individual louver setting and return to Step3.
? NOTE
All the individual louver settings are cancelled.
5.16 LOUVER OPEN/CLOSE
This function can be used to fully open the air louvers of one
specic indoor unit, in order to easily identify this unit on site.
? NOTE
• This function cannot be set when the air conditioner is ON.
• This function is invalid depending on the indoor unit type. Refer to the
user manual of indoor unit for details.
1 Select “Louver Open/Close” on the “Function Menu” and
press “OK”.
2 Press “ ” or “ ” to select "Yes" and press "OK" to open/close
air outlet of indoor units.
EN
FUNCTION MENU
PMML0565 rev.1 - 04/202235