Instruction Manual

3.5 FAN SPEED
1 Press “
” or “ to select “Fan Speed”.
2 By pressing “ ” or “ ”, the fan speed changes as follows.
? NOTE
• During dry operation, the fan speed is automatically changed to
“LOW” and cannot be changed to another fan speed. (“LOW” is NOT
displayed on the liquid crystal display (LCD) at this time. The present
setting status is displayed on the LCD).
• Some of the fan speed settings as “High2” or “Auto” may not be
available depending on the indoor unit type
3.6 LOUVER SWING DIRECTION
1 Press “
” (On/Off). Make sure that the power is ON. Press
“ ” or “ ” and select “Louver”.
2 By pressing “
” or “ ”, the louver direction changes as
below diagram , and the direction of different types of louver
is displayed differently.
LCD indication
Auto-swing
Range for COOL and DRY
Auto-swing range for COOL and DRY
Range for HEAT and FAN
Auto-swing range for HEAT and FAN
COOL, DRY
HEAT, FAN
: Auto swing operation will be started. At this time, the
louver icon on the LCD will keep swinging repeatedly.
? NOTE
• For the indoor unit without the auto louver mechanism, the indication
of “Louver” is NOT displayed on the LCD.
• The air ow angle is different for each indoor unit type. Check for
detailed information in each Operation Manual for indoor unit.
• The louver position on the LCD and the actual louver position may
not match during the Auto-Swing. To set the louver positions, set the
angle after checking the position on the LCD.
• The louver may NOT stop immediately after the switch is pressed.
OPERATION
PMML0565 rev.1 - 04/20226