Instruction Manual
Table Of Contents
- 1 Safety summary
- 2 Switch Names and Functions
- 3 Operation
- 4 Icon Description
- 5 Function Menu
- 5.1 Simple Timer Setting
- 5.2 Operation Schedule Setting
- 5.3 Power Savings Setting
- 5.4 Night Quiet Operation
- 5.5 Power Saving/Night Quiet Schedule Setting
- 5.6 Power Consumption Display
- 5.7 Autoboost (QUICK MODE) Setting
- 5.8 Comfort Setting
- 5.9 Motion sensor setting
- 5.10 Setback Setting
- 5.11 Elevating Grille
- 5.12 Filter Reminder Reset Setting
- 5.13 FrostWash
- 5.14 Individual Louver Setting
- 5.15 Cancel Individual Louver Setting
- 5.16 Louver Open/Close
- 5.17 Ventilation
- 5.18 Total Heat Exchanger Setting
- 6 Service & installation menu
- 6.1 Installation menu
- 6.1.1 Test Run
- 6.1.2 Function selection
- 6.1.3 Thermistor Selection
- 6.1.4 Input / Output Setting
- 6.1.5 Thermistor Calibration in Controller
- 6.1.6 Fan Speed at Cooling Thermo-OFF
- 6.1.7 Fan Speed at Heating Thermo-OFF
- 6.1.8 Indoor Unit Address Change
- 6.1.9 Address Check Operation
- 6.1.10 Address Initialization
- 6.1.11 Setting Initialization
- 6.1.12 Main Remote Setting
- 6.1.13 Priority Setting
- 6.1.14 Cancel Preheating Control
- 6.1.15 Elevating grille Setting
- 6.1.16 Power Up Setting
- 6.1.17 Setback Trigger Unit
- 6.1.18 Refrigerant Leak Sensor Setting
- 6.2 Service menu
- 6.3 Check Menu
- 6.1 Installation menu
- 7 Screen Display Setting menu
- 8 Contact Information menu
- 9 Hotel Mode Setting
- 10 In Alarm Condition
3 OPERATION
3.1 OPERATION START/STOP
Press “
” (run/stop). The run indicator will be turned on/off and
the operation will be started or stopped accordingly.
? NOTE
• Once the temperature and air volume settings are entered on the
wired controller, they are applied to the units. The last settings remain
displayed on the controller, being not necessary to set them again.
• When heating operation stops, indoor unit(s) may keep running in Fan
mode for about 2 minutes.
3.2 BASIC OPERATION
1 Wired controller Power ON.
Wait a few seconds to get the controller connected to the
indoor units or to other controller that may be connected to
the same indoor unit.
2 Air Conditioner OFF
When air conditioner is off, press “
” or “ ” to switch below
items:
“Temperature” ↔ “Mode” ↔ “Fan Speed” ↔ “Menu”.
- Temperature
- Mode
EN
OPERATION
PMML0565 rev.1 - 04/20223