Instruction Manual
Table Of Contents
- 1 Safety summary
- 2 Switch Names and Functions
- 3 Operation
- 4 Icon Description
- 5 Function Menu
- 5.1 Simple Timer Setting
- 5.2 Operation Schedule Setting
- 5.3 Power Savings Setting
- 5.4 Night Quiet Operation
- 5.5 Power Saving/Night Quiet Schedule Setting
- 5.6 Power Consumption Display
- 5.7 Autoboost (QUICK MODE) Setting
- 5.8 Comfort Setting
- 5.9 Motion sensor setting
- 5.10 Setback Setting
- 5.11 Elevating Grille
- 5.12 Filter Reminder Reset Setting
- 5.13 FrostWash
- 5.14 Individual Louver Setting
- 5.15 Cancel Individual Louver Setting
- 5.16 Louver Open/Close
- 5.17 Ventilation
- 5.18 Total Heat Exchanger Setting
- 6 Service & installation menu
- 6.1 Installation menu
- 6.1.1 Test Run
- 6.1.2 Function selection
- 6.1.3 Thermistor Selection
- 6.1.4 Input / Output Setting
- 6.1.5 Thermistor Calibration in Controller
- 6.1.6 Fan Speed at Cooling Thermo-OFF
- 6.1.7 Fan Speed at Heating Thermo-OFF
- 6.1.8 Indoor Unit Address Change
- 6.1.9 Address Check Operation
- 6.1.10 Address Initialization
- 6.1.11 Setting Initialization
- 6.1.12 Main Remote Setting
- 6.1.13 Priority Setting
- 6.1.14 Cancel Preheating Control
- 6.1.15 Elevating grille Setting
- 6.1.16 Power Up Setting
- 6.1.17 Setback Trigger Unit
- 6.1.18 Refrigerant Leak Sensor Setting
- 6.2 Service menu
- 6.3 Check Menu
- 6.1 Installation menu
- 7 Screen Display Setting menu
- 8 Contact Information menu
- 9 Hotel Mode Setting
- 10 In Alarm Condition
5 Press “ ”, or “ ” to select “yyyy/mm/dd/hh/mm”.
Press “
” or “ ” to change the settings.
Press and hold “
” or “ ” to increase or decrease
continuously.
The day of the week changes.
6 After making all settings:
If select “
OK
” and press “OK”, the screen returns to Step4.
If press”
”, the conrmation screen displays.
Select “Save” and press “OK” to save the setting. The screen
returns to Step4.
Select “Not Save”, the screen returns to Step4 without any
setting changes.
If press “
” again, the screen returns to Step5.
7.1.1 Time Format
Set time format
1 Select “Adjusting Date/Time” on the “Screen Display Setting”
screen and press “OK”.
2 Press “ " or " " to select "Time Format" and press "OK".
3 Press “ " or " " to select 24 hour or 12 hour and press "OK".
4 Press “ ” to return to Step2.
7.1.2 Daylight Savings Time
This function adjusts time forward or backward an hour when
daylight savings time starts or ends.
1 Select “Daylight Savings Time” on the “Adjusting Date/Time”
screen and press “OK”.
2 Press “ " or " " to select the setting and press "OK".
EN
SCREEN DISPLAY SETTING MENU
PMML0565 rev.1 - 04/202293