Operation Manual

8
English
NAIL SELECTION
SPECIFICATIONS
Type of power Piston reciprocating
Air pressure (Gauge) 4.9 – 8.3 bar (70 – 120 psi.)
Applicable nails ref. Fig.
Numbers of loadable nails 100 nails (1 strip)
Size 343 mm (L) × 305 mm (H) × 76 mm (W) (13-1/2” × 12” × 3”)
Weight 1.9 kg (4.2 lbs)
Nail-feeding method Spiral spring type
Hose (inside dia.) 6 mm (1/4”)
Max.
15 Gauge finish nails
Min.
Dimensions of nails
STANDARD ACCESSORIES
(1) Case .............................................................................1
(2) Hexagon bar wrench for M5 screw...........................1
(3) Hexagon bar wrench for M4 screw...........................1
(4) Eye protector ..............................................................1
(5) Oiler .............................................................................1
(6) Nose cap (mounted on tool)......................................1
OPTIONAL ACCESSORY
䡬 Sequential Trip Mechanism Kit (Code No. 884-320)
With the sequential Trip Mechanism Kit, the nail is
driven only by squeezing the trigger after pushing
down the push lever.
By installing these parts, driving nails into improper
positions and unexpected firing of nails caused by
accidental operation of the push lever can be
prevented.
APPLICATIONS
䡬 Manufactured Housing, On-site and Mobile Home
Construction.
䡬 Cabinets, Furniture, and Woodworking.
PREPARATION PRIOR TO OPERATION
1. Prepare the hose
Be sure to use the hose provided with minimum
6 mm (1/4”) inside diameter.
NOTE
The air supply hoses must have a minimum working
pressure rating of 10.4 bar (150 psi.) or 150 percent of
the maximum pressure produced in the air supply
system, whichever is higher.
2. Check on safety
CAUTION
䡬 Unauthorized persons (including children) must be
kept away from the equipment.
䡬 Wear eye protector.
䡬 Check the retaining screws which fix the exhaust
cover, etc. for tightness.
Check the nailer for air leaks and defective or rusty
parts.
䡬 Check whether or not the push lever works correctly.
Also check whether or not any dirt has adhered to the
moving parts of the push lever.
䡬 Recheck on operational safety.
Only nails shown in the Table below can be driven with this Nailer.
2.4mm (.095")
32mm (1-1/4")
1.1mm
(.045" )
1.8mm (.072")
65mm (2-1/2")
3.0mm
(.12")