Installation Guide

— 8 —
English
STAPLE SELECTION
WARNING
䢇 Be sure to use only the genuine HITACHI staples
for the N5021A. The use of any other staples can
result in tool malfunction and/or staple
breakdown, leading to serious injuries.
Only staples shown in the Table below can be driven with
this Stapler.
Dimensions of staples
Min. Max.
ACCESSORIES
WARNING
䢇 Accessories other than those shown below can
lead to malfunction and resulting injuries.
STANDARD ACCESSORIES
OPTIONAL ACCESSORIES
... sold separately
䡬 Sequential Trip Mechanism Kit (Code No. 876762)
(Single Shot Parts)
䡬 Pneumatic Tool Lubricant
1 oz. (30 cc) oil feeder (Code No.877153)
4 oz. (120 cc) oil feeder (Code No.874042)
1 quart (1 ltr) can (Code No.876212)
NOTE: Accessories are subject to change without any
obligation on the part of HITACHI.
APPLICATIONS
䡬 Insulation sheathing.
䡬 Wire lathing.
BEFORE OPERATION
Read section titled “SAFETY” (pages 4 – 6).
Make sure of the following before operation.
WORKING ENVIRONMENT
WARNING
䢇 No flammable gas, liquid or other flammable
objects at worksite.
䢇 Clear the area of children or unauthorized
personnel.
AIR SUPPLY
DANGER
䢇 NEVER use oxygen or
other bottled gases.
Explosion may occur.
SPECIFICATIONS
Operating pressure 70 – 120 psi (4.9 – 8.3 bar 5 – 8.5 kgf/cm
2
)
Dimensions 14-3/8" × 9-13/16" × 3"
Length × Height × Width (365 mm × 250 mm × 76 mm)
Weight 4.7 lbs. (2.1 kg)
Staple capacity 150 Staples
.40 ft
3
/cycle at 100 psi
Air consumption
(1.1 ltr/cycle at 6.9 bar)
(1.1 ltr/cycle at 7 kgf/cm
2
)
.807"
(20.5mm)
.052"
(1.33mm)
2" (50mm)
5/8"
(16mm)
.064"
(1.63mm)
16 Gauge 15/16”
Crown staple
1 Safety glasses 1
1
01Eng_N5021A_US 10/29/07, 16:528