Operation Manual

For any help concerning set up and use of your TV please call the Customer Helpline: 0845 604 0105
Getting Started
Aerial connection
Connect the “aerial” or “cable TV” plug to AERIAL
INPUT (ANT.) socket located on the back of the
TV (fi g.1).
Switching the TV On and Off
To Switch the TV On
Connect the power cord to the 220-240V AC,
50 Hz outlet.
Switch the “ ” button to position “|” so the TV will
switch to standby mode. Then the standby LED lights
up.
To switch on the TV from standby mode either:
a. Press the “ ” button, P+ / P- or a numeric button on
the remote control.
b. Press the “ ”, - or + button of the TV.
The TV will then switch on.
NOTE: If you switch on your TV via P +/- buttons on
the remote control or +/- on the TV set, the programme
that you were watching last will be reselected.
By either method the TV will switch on.
AAA/R3 x 2
Batteries
To Switch the TV Off
Switch the “ ” button to position 2 as illustrated, ( )
so the TV will switch OFF.
To power down the TV completely, unplug the power
cord from the mains socket.
NOTE: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer are
active.
fi g.1
fi g.2
Power connection
IMPORTANT :The TV set is designed to operate on
220-240V AC, 50 Hz.
Please note: After unpacking, allow the TV to reach
ambient room temperature before connecting the TV
to the mains power socket.
Connect the power cord plug to the mains power
socket.
The LED on the front of the TV then lights up, this
indicates that the TV is in ‘Standby’ mode.
Remote control - Inserting batteries
Remove the battery cover on the back of the remote
control, gently push down and pull backwards at the
same time as shown.
Insert two AAA/R3 or equivalent type batteries. Ensure
the batteries are inserted the correct way and replace
the battery cover (fi g.2).
NOTE: When the remote control is not going to
be used for long periods of time, the batteries should
be removed. Otherwise the remote control may be
damaged, caused by battery leakage and corrosion.
HD
MI 1
HDMI
2
SPDIF
Coax.OUT
HD
MI 1
HDMI
2
SPDIF
Coax.OUT
Wall Mounting
When wall mounting please ensure you use a compatible
wall mount (not supplied). This TV conforms to the VESA
mounting specifi cations and is 200 x 200mm.
NOTE: The screw size is given on the specifi cations
page.
11
01_MB60_ypbpr_[GB]_(TV-DVD)_IDTV (ARGOS)_NICKEL16_1910UK_26856W_10075067_5019XXXX.indd Ksm2:11 19.08.2011 00:02:21