Operation Manual

4
English
STANDARD ACCESSORIES
(1) Case ........................................................................... 1
(2) Bull Point (SDS-max shank) .................................... 1
(3) Side Handle ............................................................... 1
(4) Hexagon Bar Wrench (for 8mm screw) ................ 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
䡬 Demolitioning
䡬 Asphalt Cutting
䡬 Surface Roughing
䡬 Tamping
䡬 Groove digging and edging
䡬 Scooping Work
䡬 Hammer Grease A
500g (in a can)
70g (in a tube)
30g (in a tube)
Optional accessories are subject to change without
notice.
APPLICATIONS
Demolishing concrete, chiseling concrete, grooving, bar
cutting, and driving piles.
Application examples:
Installation of piping and wiring, sanitary facility
installation, machinery installation, water supply and
drainage work, interior jobs, harbor facilities and other
civil engineering work.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
4. Installing Tools
CAUTION
To prevent accidents, make sure to turn the switch
off and disconnect the plug from the receptacle.
NOTE:
When using tools such as bull points, cutters, etc.,
make sure to use the genuine parts designated by
our company.
SPECIFICATIONS
Model H 60MA H 60MB
Voltage (by areas)* (110V, 230V, 240V)
Power Input 1300W*
Full-load Impact Rate 1600/min. 900–1600/min.
Weight (without cord, side handle) 10.5 kg
*Be sure to check the nameplate on product as it is subject to change by areas.
(1) Bushing Tool
(2) Shank
(1) Bull Point
Overall Length: 280, 400 mm
(1) Rammer
(2) Shank
(1) Cold chisel
Overall length: 280, 400 mm
(1) Scoop
(1) Cutter