Manual

English I

ASSEMBLY PROCEDURES

_WARNING

Never try to start engine without side case

securely fastened,

1. Remove chain bar clamp nuts (1).

2. Remove the side case (2) as pinching the rear

part of the side case (2). (Fig. 1)

NOTE

Slightly move the bar back and forth and make

sure the chain tension boss (7) fits into the hole

(8) in the bar properly. (Fig. 3)

4. Confirm the direction of saw chain (9) is correct

as in the figure, and align the chain on the

sprocket. (Fig. 4)

Fig. 1

* In case of installing the spiked bumper (3),

install the spiked bumper (3) (if so equipped) to

the unit with two screws. (Fig. 2)

Fig. 4

Guide the chain drive links into the bar groove all

around the bar.

Install the side case (2) onto the bolts (5).

Then tighten the clamp nuts (1) temporarily.

(Fig. 1)

Raise the bar end, and tighten the chain (9)

by turning the tension adjustment bolt (10)

clockwise. To check proper tension, lightly lift

up the center of chain and there should be about

0.02 - 0.04 " (0.5 - 1.0 mm) clearance between

bar and edge of drive link (11). (Fig. 5, 6)

Fig. 2

3. Install the chain bar (4) onto the bolts (5), then

push it toward the sprocket (6) as far as it will go.

Make sure that the boss of chain tension adjust

bolt (7) fits into the hole of the bar (8). (Fig. 3)

6 4

Fig. 3

Fig. 5

Fig. 6