User`s manual

37
Operating
PbyP (Picture by Picture)
<Only for CP-WX8240A, CP-WX8255A, CP-WU8440 and CP-WU8450>
The PbyP is a function for displaying two different picture signals on a screen that
is split into main and sub areas for each signal.
The setting information will be appeared for
several seconds when the PbyP function is started.
Displays the input information for each area. A
yellow frame around the main area and an audio
mark indicating the audio output will also be
displayed. The information can be redisplayed with
the ◄/► buttons after it has been erased.
PbyP
button
The position of the main area can be
toggled with the ◄/► buttons when the
setting information is displayed on the
screen. The yellow frame and the audio
mark will move together with it.

Changing the main area
• If the LAN or USB TYPE A / B port is selected when the PbyP button
is pressed, input from other port is displayed on the main area.
• When in the PbyP mode, use the MENU button on the remote control or ▲/▼
buttons on the control panel to display the OSD menu.
• There are certain functions that cannot be used when in the PbyP mode.
• A message will be displayed when buttons that cannot be used are pressed
(
119). However, note that there are certain unusable buttons for which
messages are not displayed.
• The functions on the OSD menu that cannot be used are displayed in gray
and cannot be selected.
NOTE
main
area
sub
area
main
area
sub
area

Setting information
Press the PbyP button on the remote control. This acctivates the PbyP mode. The
screen displayed before the PbyP button was pressed will be displayed as the
main area. Most of operations are effective for the main area only. Only outputs
the audio input signal paired with the picture input signal for the main area.
To quit the PbyP mode, press the PbyP button again.
Normal mode PbyP mode
main
area
sub
area
main area sub area
Input information
Audio mark
(continued on next page)
Frame