Owner's Manual

18
ENGLISH
OTHERFEATURES
(continued)
Signal Check
The status of signal reception is checked automatically and the result is displayed on the
screen.
RGB1 [D-SUB]
H : 46.5kHz, V : 60Hz
POWER SAVE
OUT OF FREQUENCY
Status Display Action
Signals are received
normally.
The input terminal and the
horizontal and vertical
frequencies are displayed in
a guidance image.
A sync signal could
not be detected.
The guidance message
“POWER SAVE” is displayed
for about 5 seconds.
In the event of continued
absence of a sync signal, the
power indicating lamp flickers
and the monitor enters power
save mode.
Check the power
switch of the PC
and its status of
connection.
The input signal
does not meet
display
specifications or
erratic.
The guidance message
“OUT OF FREQUENCY” is
displayed for about 5
seconds.
Check the input
signal
specifications
once again.
Either VIDEO or S VIDEO is displayed
on VIDEO input.
The input signal
appears
compressed
(reduced display).
The input terminal and the
horizontal and vertical
frequencies are displayed in a
guidance image, along with
the message “DOT
COMPRESSION”
RGB1 [D-SUB]
DOT COMPRESSION
H : 63.7kHz, V : 60Hz
25 27
Reset (Settings Initialization)
The EasyMenu shown to the right will be displayed when the
SELECT button is used to select DISPLAY and moreover
DISPLAY INT is selected from the On-screen Display
System Easy Menu . If the key (select YES) of the
SELECT button is pressed at this time, the user adjustment values in the table below for the
signal currently being received will be deleted and the factory settings will be restored.
Pressing the key (select NO) cancels deletion and returns the DISPLAY menu.
INITIALIZE ?
YES NO
DISPLAY menu item Display
H.POSITION H.POSITION
V.POSITION V.POSITION
CLOCK CLOCK
12
Application
RGB1, RGB2
RGB1, RGB2, VIDEO1, VIDEO2
RGB1, RGB2
PHASE PHASE RGB1, RGB2
Scan system SCAN RGB1, RGB2
Display size DISPLAY SIZE VIDEO1, VIDEO2
Display area DISPLAY AREA RGB1, RGB2
Vertical size V. SIZE VIDEO1, VIDEO2