Operation Manual

13
English
SELECTION OF BLADES
To ensure maximum operating efficiency and results,
it is very important to select the appropriate blade best
suited to the type and thickness of the material to be
cut. Select appropriate blades by referring to Table 2.
NOTE
䡬 Dimensions of the workpiece mentioned in the table
represent the dimensions when the mounting
position of the base is set nearest to the body of
the Cordless Mini Saw. Caution must be exercised
since dimensions of the workpiece will become
smaller if the base is-eounted far away from the
body of the Cordless Mini Saw.
NOTE:
䡬 The minimum cutting radius of No. 1 (Long), No. 1 (Super Long), No. 21, No. 22 and No. 41 blades is
100 mm.
䡬 Usable blade thickness: 0.8 mm to 1.5 mm.
Table 2 List of appropriate blades
Material
Blade
No. 1 No. 1
No.11 No. 12 No. 15 No. 16 No. 21 No. 22 No.41 No. 97
123X
to be cut
(Long) (Super Long)
Material quality Thickness of material (mm)
Lumber
General lumber
Below Below 10 ∼ Below 10 ∼ 5 ∼ 10 ∼
50 50 50 20 50 40 50
Plywood
5 ∼ Below 5 ∼ 3 ∼
30 10 30 20
Iron plate
Mild steel plate
3 ∼ Below 2 ∼ 1.5 ∼
43 34
Stainless steel plate
1.5 ∼
2
Nonferrous
Aluminium copper,
3 ∼ Below Below
metal
brass
83 5
Aluminium sash
Height Height Height
up to up to up to
20 20 20
Plastics
Phenol resin, melamine, 5 ∼ Below 5 ∼ Below 5 ∼
resin, etc. 15 6 10 6 10
Vinyl chloride, 5 ∼ Below 5 ∼ Below 5 ∼ 3 ∼ 5 ∼
acryl resin, etc. 20 10 15 5 20 15 10
Foamed polyethylene, 10 ∼ 3 ∼ 5 ∼ 3 ∼ 10 ∼ 3 ∼ 5 ∼
foamed styrol 50 25 25 25 50 40 25
Pulp
Card board, 10 ∼ 3 ∼ 10 ∼ 3 ∼
corrugated paper 50 25 50 40
Hardboard
3 ∼ Below 3 ∼
15 6 15
Fiberboard
Below
6
01Eng_CJ10DL_WE 8/3/09, 12:2913