Operation Manual

GB-22
Set the alarm timer
This unit can be used as an alarm clock. You can select DISC, USB or TUNER as alarm source.
Note:
■ Ensure that you have set the clock correctly.
1. In standby mode, press and hold the
TIMER
button until [TIMER SET] (set timer) scrolls on the
display.
2. Press
H
/
G
/ VOL +/–
button on the remote control or on the front panel to select source.
3. Press
TIMER
button to conrm. The hour digits are displayed and begin to blink.
4. Press
H
/
G
/ VOL +/–
button on the remote control or on the front panel to set hour, and
then press
TIMER
button again.
The minute digits are displayed and begin to blink.
5. Press
H
/
G
/ VOL +/–
button on the remote control or on the front panel to set minute, and
then press
TIMER
button to conrm.
6. Press
VOL +/-
to adjust volume, and then press
TIMER
button to conrm.
A clock icon appears on the display.
Activate / deactivate alarm timer
1. In the standby mode, press
TIMER
button repeatedly.
* If timer is activated, the icon is displayed.
* If timer is deactivated, the icon disappears on the display.
Note:
■ The alarm timer is not available when the source is set as "AUX".
■ If the USB source is selected but no device connected, the unit switches to TUNER automatically.
Set sleep timer
This unit can switch to standby mode automatically after a set period.
1. When the unit is turned on, press
SLEEP
button repeatedly to select a preset period (in minutes).
When the sleep timer is activated, SLEEP icon “ ” displayed.
* To deactivate the sleep timer, press
SLEEP
button repeatedly until [OFF] (sleep off) appears.
OFF
120 90
...
45 30 15
01_AXM649BT_GB_P41013409-A101_20 Mar 13.indd 22 2013-3-20 9:44:23
Downloaded from www.vandenborre.be