Operation Manual

GB-15
Setting the Clock

Setting the Clock Manually
1. Set the unit in eco power standby mode.
2. Press and hold the Clock button (
CLOCK
), the VFD will display CLOCK SET and CLOCK 24
begins to blink.
3. Set the hour with the Volume Up/Down button (
VOL+/-
) or Previous/Next buttons (
H
/
G
).
4. Press the Clock button (
CLOCK
), the minute indicator will blink.
5. Set the minute with the Volume Up/Down button (
VOL+/-
) or Previous/Next buttons (
H
/
G
).
6. Press the Clock button (
CLOCK
), the built-in clock starts operating.
Note:
• When the clock setting time for each step is longer, the clock setting mode will be cancelled.
• If a power failure occurs or the unit is disconnected from the mains, the clock setting will be lost.

Setting the Clock Automatically
Tune into a RDS station and wait for few minutes. To conrm, press the Clock button (
CLOCK
).

Display the Clock
In standby mode, press the Clock button (
CLOCK
).
Sound Quality
Adjusting the Volume
To increase or decrease the volume, rotate the Volume Control knob (
- VOLUME +
) on the unit or
press the Volume Up/Down buttons (
VOL +/-
) on the remote control.
Adjusting the Super Bass
You can reinforce the bass sound to maintain rich, full bass at low volume.
Press the Super Bass button (
S-BASS
) on the remote control to get the effect, the word “DBB” will lit
on the front panel. Press the Super Bass button (
S-BASS
) again to cancel the effect.
Adjusting the Bass
Rotate the BASS knob clockwise or counter clockwise on the Amplier to adjust the intensity of the
bass output sound.
Adjusting the Treble
Rotate the TREBLE knob clockwise or counter clockwise on the Amplier to adjust the intensity of
the treble output sound.
Controlling the Loudness
This unit has a loudness function, which can automatically increase the bass sound effect at low
volume. It can also increase the bass sound effect at high volume, but it will be relatively less when
it is at high volume. Press the Loudness button (
LOUDNESS
) on the remote control to obtain the
loudness function, the icon “
” will display on the front panel, press again will disappear.
Presetting Equalizer
You can adjust the sound reproduced simply by choosing from 5 preset equalizers. Press the Pre-
set Equalizer button (
P-EQ
) repeatedly to scroll through the following options:
Changing the Front Panel Darkness
This unit has three brightness levels for you to adjust the clock display. Press the Dimmer Control
button (
D M
) on the front panel or the remote control repeatedly to choose the desired brightness.
FLAT POP JAZZ ROCK CLASSIC
01_AXM649BT_GB_P41013409-A101_20 Mar 13.indd 15 2013-3-20 9:44:05
Downloaded from www.vandenborre.be