Manual

SETUP
Video 2 Auto Link Use this function to automatically turn the TV on and tune to Video2 when it detects a video signal to
input 2.
_Setup
Rename List
F
Videol_AVR ODVD ©PVR OSTB2
Video2 _ OCAM ODVD20PVR2 OVCR
Video30CBL ODVD30SAT OVCR2
Video40CBL2 OLD OSTB OVCR3
Video5 Reset
I ; Move ;SELJRet. r_ ]
ISetup D
liszt
Rename List
Video1 _AVR ODVD OPVR OSTB2
_ A! OVeR
= © CAI_1 ODVD20PVR2
Video3 ©CBL ODVD3 ©SAT OVCR2
Video4 OCBL2 OLD OSTB OVCR3
Video5 @Reset
Auto Link
Auto O Remote @ Off
[ ; Move L_E_3Ret. r_
Use the CURSOR buttons _1, I_, • or V, then press the SELECT button to change AUTO LINK setting.
When AUTO is selected, the TV will turn on and tune to Video2 automatically, when the Video2 input device is turned on. This is con-
venient when you want to watch a movie with your VCR, laserdisc player, or DVD player.
When REMOTE is selected, the TV will turn on and switch to Video2 automatically when the Video2 input device is turned on and the
VCR, laserdisc, or DVD play button on your remote control is pressed.
This is convenient when you want to record a movie with your VCR and watch it later.
Select Off to disable this function.
Press EXIT to quit menu.
NOTES:
1. Once the TV has been turned on using the AUTO LINK feature, it must be reset before AUTO LINK is used again. To
do this, turn your VCR, laserdisc, or DVD player OFR This feature is now reset and will turn on your TV as described
above.
2. When using REMOTE mode, any remote control button will substitute for your video input device play button. However,
intended operation is for use with your VCR, laserdisc, or DVD play button.
3. If no remote control button is pressed after the TV is turned on by AUTO LINK, the TV will automatically turn off after
three hours.
6O