Manual
SETUP
Manual Convergence Adjustment Mode (117 Point Manual Adjustment)
I NOTES: 1. Please turn ON your television for at least 20 minutes before using this feature.
2. Auto Adjustment Mode is recommended. If convergence is still net acceptable, use the Manual Adjustment Mode.
3. If Auto Adjust mode is selected or the Magic Focus button is pressed, all manual adjust mode settings will be erased.
Using the Remote Control, select SETUP-MAGIC FOCUS TUNE UP-MANUAL ADJUSTMENT MODE-117 POINT MANUAL-START to
access convergence 117 point pattern. The adjustment point is indicated by the Adjustment Point Cursor.
To Move Adjustment Point
To move the adjustment point cursor using the CURSOR buttons, the Adjustment Cursor must be WHITE. Another way to move the
Adjustment Point Cursor is to press the following buttons: [2] up, [4] left, [5] down, [6] right. If you use the number buttons while the
adjustment point is WHITE, it will change to RED.
To Change the Color of Adjustment Point
Press the SELECT button repeatedly (WHITE-RED-BLUE-WHITE...). Green color is fixed and cannot be adjusted.
To Adjust the Convergence
Move the Adjustment Cursor to the point to be adjusted. Use the CURSOR buttons to match the RED and BLUE colors to GREEN
(reference color). Properly aligned, all three colors should appear white.
MENU
_Vi deo III
|_e_ II
_Lhan. Manager
|Lo_ II
|'_...... II
I
Move _,@ELISel ]
mSe_up
mM_g
mSet the _nputs m
mSet virtual i_D m
mSet _ack Side Panel m
mSet closed Captions m
mset Monitor Out m
_J_About Your rv vm
_FSe_up M
Aligns _he Red, Creen, and Blue
colors _o correc_ for Magnetic
influences.
Adjus_men_ Mode
_OAu_o n A_ _urn off,
I O9 Poin_ Manual (After 9O days).
117 Point Manual
if you wan_ _o adjust now---=_
J Adjustment Point
Cursor
/
f
/
/
/
If convergence is acceptable after Manual Convergence adjustment, press EXIT button to access menu mode.
_Setup
m
AdjUS .....
Please make a selection from
the op low
EXE0 _
Use the CURSOR buttons to highlight your chosen option. Press the SELECT button to select.
Select CANCEL to cancel adjusted data and return to main picture.
Select DONE to save your adjustments and return to the main picture.
Select BACK to return to the manual convergence adjustment mode.
Select RESET to recall the factory pre-set convergence data.
57