Manual

REAR PANEL JACKS

_ CableCARD Slot

This slot is for the CableCARD that will be provided by your local cable operator to gain access to chosen cable channels. The

CableCARD will allow you to tune digital and high definition cable channels. Please call your local cable operator if this service is

available before requesting a CableCARD (also known as Point of Deployment (POD) module).

Connect a coaxial cable to ANT A terminal of the Rear Panel Jacks.

Insert the CableCARD into the slot (Top of card should be facing right as shown).

If the CableCARD is properly installed or not installed, the TV will display the following respective screens.

CableCARD is installed]

CableCARD

is not installed

After the CableCARD is installed, wait until the second screen below appears. The third screen below will appear if a channel is not

authorized for viewing. Press the EXIT button to exit the second screen.

Acquiring Data.

Please wait.

i_ orde_ zo szarz cable service

for this device, please co_tact

your cable provider

CableCARDCZm): 123-4S6-7891

Host: 123-4S6789-Z

Daza: 123-,_$6-,7_9-,_

Not an Authorized Channel I

Please take note of all information on the screen (you will provide this information to your cable operator). Call your cable operator

and give them the information from the card to start your cable service.

NOTES: 1. A digital cable subscription is required.

2. Antenna B will not be available when CableCARD is inserted.

3. Do not insert a PCMClA card into the CableCARD slot.