Manual

PICTURE-IN-PICTURE (PIP)
PICTURE-IN-PICTURE CONT.
SURF MODE PIP
This feature will automatically scan all active channel numbers (those set in memory) and displaythem as PIP sub-pictures, along
the right edge of the screen. Press the PIP button a second time to remove the sub-pictures from the screen.
I NOTE: 1. If no buttons are pressed when in SURF mode, auto-scanning will continuouslyscan.2. If a channel is tuned during this SURF scanning, sub-pictureswill be removed from the screen.
_ SWAP button
If you wish to switch what is being shown on the main picture to the sub-picture, press the SWAP button.
I
I
NOTE: 1. The SWAP button will only operate when SINGLE PIP mode is chosen.
2. The SWAP functionwill not operate if ANT B inputis set as the main channel (ANT B input cannot be displayed as
I
a sub-picture.)
(_) MOVE button
To move the sub-picture to another comer, press the MOVE button. The sub-picture moves one step counterclockwise every
time the MOVE button is pressed. (Example below illustrates the MOVE operation for initial shipping conditions. If you have
customized a PIP position, the MOVE operation may differ slightly from this example.)
ANT A 10
VIDEO: 1
,$_SINGLE
OSURF
i
ANT A 10
VIDEO: 1
ANT A 10
VIDEO: 1
ANT A 10
VIDEO: 1
It is also possible to customize the PIP position. To do this, wait until the On-Screen Display disappears (about eight seconds)
and then use the CURSOR A,Y,b,,,< buttons.
AFTER
EIGHT
SECOI_
25