Manual

HOW TO USE THE GENIUS REMOTE TO CONTROL YOUR TV
(_ PICTURE-IN-PICTURE buttons
See separate section on page 24 for a description.
(_) PIP CH button
Use the PIP CH button to select between main picture and sub-picture tuning. The channel number which is green indicateswhich
channel is being controlled.
(_ HELP button
Press this buttonwhen a menu is displayed to view HELP text, which gives a descdption of the displayed menu. The HELP text will
be displayed every time a MENU isdisplayed, untilthis buttonis pressed again or the AUTO HELP FUNCTION is set to OFF. (See
page 58.)
CONTRAST 1_ 411m_ll_ 100%
BRIGHTNESS _ _:_:::3 DI,50%
COLOR ,_IIn'-'--'--Ib, 5O%
TINT .qr"_n-----lb.
SHARPNESS _ m_---_'-II_ 50%
RESET []
ADVANCED
SETTINGS
MENU ITO MENU BAR TO QUIT I EXIT
f
1_IplI('-'_W( PRESS b, FOR A DEEPER
PICTURE, PRESS • TO
DECREASE CONTRAST
CONTRAST
BRIGHTNESS
COLOR
TINT
SHARPNESS
RESET
ADVANCED
SETTINGS
4_b 5O%
4_----'1b 50%
< r'-'-mml---lb,
<__'qb 50%
[]
MENU ITO MENU BAR TO QUIT JEXIT
q_) LAST CHANNEL (LST-CH)
button
Use this button to select between the last two channels viewed. (Good for watching two sporting events, etc.)
LST-CH
(_ VOLUME, MUTE buttons
Press the VOLUME up (A) or down (V) button untilyou obtain the desired sound level.
To reduce the sound to one half of normal volume (SOFT MUTE) to answer the telephone, etc., press the MUTE button. Press the
MUTE button again to tum the soundoff completely (MUTE). To restore the sound, press the MUTE button one more time, or press
the VOLUME Up (/_O button.
MUTE MUTE
(_) CHANNEL SELECTOR buttons
CHANNEL SELECTOR buttons are used to set Family Favorites, Channel Memory, etc.
Enter two or three numbers to select channels. Enter "0" first for channels 1 to 9. For channels 100 and above, press the "1"
button, wait unUI another dash appears next to the channel display on your TV, then enter the remaining two numbers using the
number buttons.
Channel selection may also be performed by pressing CH up (A) or down (Y).
I NOTE: The IV may not receive some channels if you are not in the correct SIGNAL SOURCE mode. (See page 35.) I
22