Manual

SETUP

Video 2 Auto Link | Use this function to automatically turn the TV on and tune to Video2 when it detects a video signal to

input 2.

I Se_u P

set The l_put_ _{

Video1 Rename

Video2 Rename

Video3 Rename _1

Video4 R_na_e

Video_ R_na_e

CURSOR

I Setup

_set T_e tnput_

_Vov_ _Return

set T_e _put_ _]

_deo2 Auto L_nk _1

¢_ov_ _ Set_t I

Use CURSOR • or _', then press the SELECT button to change AUTO LINK setting.

When AUTO INPUT SIGNAL SENSOR is selected, the TV will turn on and tune to Video2 automatically, when the Video2 input device

is turned on. This is convenient when you want to watch a movie with your VCR, laserdisc player, or DVD player.

When REMOTE CONTROL SENSOR is selected, the TV will turn on and switch to Video2 automatically when the Video2 input device

is turned on and the VCR, laserdisc, or DVD play button on your remote control is pressed.

This is convenient when you want to record a movie with your VCR and watch it later.

Select Off to disable this function.

Press EXIT to quit menu.

NOTES:

1. Once the TV has been turned on using the AUTO LINK feature, it must be reset before AUTO LINK is used again. To

do this, turn your VCR, laserdisc, or DVD player OFE This feature is now reset and will turn on your TV as described

above.

2. When using REMOTE CONTROL SENSOR mode, any remote control button will substitute for your video input device

play button. However, intended operation is for use with your VCR, laserdisc, or DVD play button.

3. If no remote control button is pressed after the TV is turned on by AUTO LINK, the TV will automatically turn off after

three hours.