Manual

USING THE GENIUS REMOTE TO LEARN ADDITIONAL
FUNCTIONS FOR CLU-850GR
Storlng Operation
®
Set the remote transmitter as shown below.
Put the remote transmitter which contains the codes to be stored and the GENIUS REMOTE transmitter toface each
other. (Distance should be 2-4 inches.)
®
000s!2'inchsI ,I
n IInnooU -_ _' _ _/
nO nIIOo,=nII 't°)I _ GP e e ,_,c
!
/
®
Remote control to be stored
GENIUS remotecontrol
_) Set the LEARN/USE mode select switch located on the back of the Genius Remote to the LEARN position.
_) Set the MULTI-PAGE select switchto "USER"position.
_) Press of the learnablebuttons the Genius Remote, ("7"in thisexample).This buttonwillbe usedto store
one on
the newcode. The READY indicatorwillflash at thistime. (The lightwillremain litfor approximately15 seconds.
If no otherfunction is performedat thistime, the operationis canceled.)
READY LEARN
(flashing) (off)
The GeniusRemoteis readyto receivean infraredcode
from anotherremote.
Pressand holdthe buttondownontheothertransmitterwhichcontainsthecodetobestored,whilethe light
READY
isflashingon the GeniusRemote.
Releasethe buttonafterboththe READY and LEARN indicatorslightand thengo off.
39