Manual

USING THE GENIUS REMOTE TO CONTROL VCR FUNCTIONS
erating the pre-Coded function for your VCR
sGeniusRemoteisdesignedtooperatedifferenttypesofVCRs.YoumustfirstprogramtheGeniusRemotetomatch
, remotesysteminyourVCR. (Refer to Table 1 on page 36 or Table 3 on page 37.)
Set the MULTI-PAGEselectswitchto"VCR."
Set the USE/LEARN mode select switch on the rear side of the Genius Remote to "USE." (For CLU-850GR only)
Turn ON your VCR.
Aim theGeniusRemotecontrolat thefront ofyourVCR.
Whileholdingdownthe SELECT button,pressthebuttonthatmatchesyourVCR as shownonpage 36 or page
37. Continueto holddownboth buttons.The channelsof the VCR willbeginchangingwhenthe correctbuttonis
pressed. When thisoccurs,the GeniusRemoteControlisprogrammedfor yourVCR. Ifthe VCR channelsdo not
changeafter5 seconds,try a differentGeniusRemotebutton.
Releasebothbuttonswhenthe VCR startsto changechannels.The Genius Remotewillnowcontrolyour VCR.
NOTES:
1. IfyourVCR cannotbe operatedafterperforming
the above procedures, this means that your
VCR's codeshave not been precodedintothe
GENIUS REMOTE. Please store your VCR
codes in memory by using the USER mode.
(Refer topage 38.)
2. The GENIUS REMOTE CONTROL willremem-
ber the codesyouhaveprogrammedinuntilthe
batteriesare removed from the GENIUS RE-
MOTE CONTROL. After replacingthe batteries
repeat theentireprogrammingprocedurestated
above.
3. If you have a play back only VCR (no CH UP/
DOWN function), pleasefollow operatingstep5
describedabove andthenchecka VCR function
untilyoufindthebuttonthatwillallowtheprecoded
VCR buttonsto operateyour VCR.
PRECODED VCR BUTTONS
Thesebuttonsalwaystransmitthechosenpreceded
VCR codes.
SELECT BUTTON
Thisisfor settinguptheGeniusRemotetotransmit
theVCR's remotecodes.
) EXCLUSIVE TV BUTTONS
These buttonsarefor operatingtheTV.
34
r_- ..... ::==:1
READY LEARN
p,v = II II o !
II 0O II II !IsE_ECTI_-
i
.o°,/
i' _O
_..'_" I _ I'J/=_ o
-.o
® -
®®®i
®®@J
.......;::._r,.7::-i_ ,® i
io ii( oi
i :=======================
H FF/U_HI
GENIUSREMOTE
CL_R