Manual

__ HOW TO USE THE GENIUS REMOTE TO CONTROL YOUR TV

ANT button (35UX60B only)

Use the ANT (Antenna) button to select between the VHF/UHF and AUX (Auxiliary) antenna inputs.

NOTE: When VHF/UHF is selected, the channel number in the upper right corner of the screen isin green. When I

the AUX input is selected, the channel number is in yellow.

t MENU, ENTER, CURSOR buttons

All the on-screen display features can be set or adjusted by using these buttons.

The "MENU" button will start or exit the on-screen display.

The =CURSOR" buttons will highlight functions or adjust different features.

These buttons are also used for FAVORITE CHANNELS. (see Page 47.)

The "ENTER" button will set features to your preference.

"CHANNEL SELECTOR" buttons are used to set the time, for channel memory, etc..

I CHANNEL SELECTOR buttons

Enter two or three numbers toselect channels. Enter a "0"first forchannels I to 9. Use the"100" button for channels

100 and higher.

Channel selection may also be performed by pressing channel up ( • ) or down (• ).

NOTE: The TV may not receive some channels ifyou are not in the correct AIR/CABLE mode. See page 44. I

) AVX button

The AVX (Auxiliary Video) button will select between the antenna signal and the three sets of video input jacks each

time the button ispressed. Ifthe Picture-in-Picture (PinP) is on, the AVX will select between the three sets of video

input jacks. (See page 32.)

I °°IL_

T I

AVX AVX

C> O

I v'°E°31

_ AVX

VIDEO:2