- HITACHI Operating Guide 36" PC READY COLOR TV 32HDL52A, 37HDL52A

English

SETTING UP YOUR DTV

1. On the Channel menu page, select the third item MANUAL SCAN.

2. Press W or X to highlight the input column, then press numeric buttons to input

the channel number. The channel frequency will be automatically showing on

right side of the input column.

3. Press SEL button when the message “Add channel” and “press Enter to add

channel” has shown.

4. If the ATSC signal is found and locked, the Status

will show message “Add No.

XX 8VSB channel

successfully”. Then you can press EXIT to leave the menu

page and watch the program, or

go ahead scanning the other channels.

5. If the signal is not locked, the status will show “No Channel NO. ”. You can scan

the signal again or refer to the signal level bar “Signal” for aligning the direction of

the antenna to get the signal.

6. When the signal is locked and the receiver is on the channel, you can enter into

this page to check the signal level.

1. On the Channel menu page, select the first item EDIT.

2. Press ▲▼ and W X buttons to highlight the channel’s BLOCK or FAV control

column and press SEL to block channel or copy channel into the favorite

channel list “F1”.

3. After the edit setting, press the RTN button, then

will pop up a confirmation

window: choose “NO” to cancel the edit

change; choose “YES” to save the edit

settings.

Manual Scan

Note: It’s suggested that you contact the antenna Installer when you have trouble of locking the signal.

Edit

Note: When the blocked channel has been selected, the program can not be showed, and you will get the message:" Channel is

blocked” from TV