User Guide

- 55 -
No-Signal Detection (TV)
If no valid signal detected, it takes 5 minutes
for the set to switch to Standby mode unless
a signal is detected or a command is re-
ceived from the remote control.
After a Remote Control command (if No-Sig-
nal Timer is active) the timer stops and if no
signal detected again the timer is initialized
to 5 minutes and starts 3 seconds later
again to count down.
It is not valid in AV mode.
No-Signal Detection (PC)
If no valid signal detected for 5 minutes sys-
tem goes to Stand-By mode. To switch on
the system press   button.
As the last status feature, system starts from
TV or PC, whichever was the status before
stand-by or switch-off. Note that SCART in-
puts have the precedence on both TV and
PC.
Volume Bar
It is displayed in the lower middle of the
screen. When a volume command is re-
ceived (pressing 
+ or  - by Re-
mote Control or Control panel at the top of
the TV) and no menu is active, it stays on the
screen for 3 seconds, after the last volume
command or until another command is re-
ceived in between.
AV Modes
By pressing the   button you can switch
your TV to AV modes (except being in Tele-
text). Pressing this button will consecutively
switch the TV in one of the optional AV
modes: AV-1, AV-2, AV-3, S-VIDEO, PC.
In order to quit the AV mode press the 
,
digit buttons or -P/CH or P/CH+ .
Signal Out Of Range
When the PC input signal is not supported
by LCD-TFT TV, a message is displayed like
Signal out of range and screen is blanked.
PC MODE
Installation
 Power off both Computer and Display before
making any connections.
 Connect one end of the optional 15 pin sig-
nal cable to the 15 pin connector on the PC
and the other end to the 15 pin socket on the
TV.
 Tighten the screws of the Display cable until
the connectors are fastened securely (fin-
ger-tighten only).
 If you are using Windows operating system
running on a PC with a Microsoft Plug & Play
compatible video card, your system will se-
lect the appropriate timing for your monitor.
Switching from TV to PC
Press PC button to switch directly PC
mode.
Main Menu in PC mode:
Enter the main menu by pressing the M
button on the remote control.
2-ENG-1700W-1547UK-17 INCH TFT-WM-17LD4220.p65 01.12.2004, 14:1955