Datasheet

Z5K500 OEM Specifications

132

14.35 Sense Condition (F0h : vendor specific)

Command Block Output Registers Command Block Input Registers

Data - - - - - - - - Data - - - - - - - -

Feature 0 0 0 0 0 0 0 1 Error ...See Below...

Sector Count - - - - - - - - Sector Count V V V V V V V V

LBA Low - - - - - - - - LBA Low - - - - - - - N

LBA Mid - - - - - - - - LBA Mid - - - - - - - -

LBA High - - - - - - - - LBA High - - - - - - - -

Device - - - - - - - - Device - - - - - - - -

Command 1 1 1 1 0 0 0 0 Status ...See Below...

Error Register Status Register

7 6 5 4 3 2 1 0 7 6 5 4 3 2 1 0

CRC UNC 0 IDN 0 ABT T0N AMN BSY RDY DF DSC DRQ COR IDX ERR

0 0 0 V 0 V 0 0 V V V - V - 0 V

Table 105 Sense Condition Command (F0h)

The Sense Condition command is used to sense temperature in a device.

This command is executable without spinning up even if a device is started with No Spin Up option.

If this command is issued at the temperature out of range which is specified for operating condition, the

error might be returned with IDN bit 1.

Output Parameters To The Device

Feature

The Feature register must be set to 01h. All other value are rejected

with setting ABORT bit in status register.

Input Parameters From The Device

Sector Count

The Sector Count register contains result value.

Value Description

00h Temperature is equal to or lower than -20 degC

01h-FEh Temperature is (Value / 2 - 20) deg C

FFh Temperature is higher than 107 degC

Not recommendable condition for start up. If over stressed condition

is detected, this bit will be set to one.