User's Manual

9 / 20
2. Installation of the Biometric Reader
2.1 Place the Biometric Reader
Install the Biometric Reader on a horizontal and stable place. Ensure no light through a window
or from lamps can enter the scanning area of the Biometric Reader.
It is recommended that you use the Biometric Reader in the 300-1000 lx luminance range,
which is equivalent to the brightness suitable for reading a newspaper.
Important
 Do not use the Biometric Reader in places where the Biometric Reader is exposed
to strong light such as outdoors, near windows or near a light source, which may
lead to an authentication failure.
2.2 Power On
Slide power switch (left side of the unit) to power on.
USB mode
Power OFF
Bluetooth mode
With USB cable connection
(powered by USB)
- Power On
- Connected by USB
- Power Off
- Power On
- Connected by Bluetooth
Without USB cable connection
(powered by internal battery)
- Power Off
- Power Off
- Power On
- Connected by Bluetooth
Important
 Reader Unit can’t power on by USB mode without USB bus power.
 Reader Unit may hold some heat due to the use of infra-red rays inside, but this
will not cause malfunctions.
 Do not connect more than two Reader Units simultaneously to one PC. If multiple
Reader Units are connected, they will not work properly.
 After connecting the Reader Unit to your PC, wait for at least 5 seconds before
performing any operation.
USB mode
Bluetooth mode
Power Switch
Power OFF