User Manual
Table Of Contents
EnglishEnglish
Preparaon: Take out the iron-plated holder, Pluck off the
an-skid cap, then remove the protecve film on the bar. Find
the Hex Wrench.
Howtoassemblethedevice
Part1:InstallingthesupportBase
Take out the base board, and screw the thick support bar on 1:
Install the connector on the support rod, clasp the toggle clip,
fix the connector on certain posion.
2:
Screw the cross bar on the main machine.3:
insert the cross-bar, and lock it in appropriate place.4:
Cover the metal stand with non-slip rubber sleeve.5:
02 03