X08060306B
SAFETY INFORMATION
SAFETY INFORMATION 1. The manufacturer reserves the right for any modifications on the product which might be deemed necessary or useful without informing about it in this IFU. 2. Before operating your new washing machine, please read this instruction carefully, and keep it for future reference. If you have lost it accidentally, ask customer service for ecopy or hard copy. 3. Please make sure the socket is grounded securely, the water source connection is reliable. 4.
19. Fabric softeners, or similar products, should be used as specified by the fabric softener instructions. 20. Remove all objects from pockets such as lighters and matches. 21. WARNING: Never stop a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. 22.
that ing that the The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for there cyclingof electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal.
Clean the outside of the washing machine with a damp cloth. Do not use abrasive detergents. Never open the door forcibly or use it as a step. recommend that you carry out a short wash cycle without laundry. 2 Close the door. 1 3 Pour a little detergent (about 30 ml) into the main wash chamber 2 4 of the deter- gent dispenser . 4 Select and start a short programme (see separate quick reference guide). 5 PREPARATION OF THE WASHING 1. Sort the laundry according to...
Open the door. .
unds Press the release lever in the main wash compartment downward and remove the drawer(fig.“B”). Remove siphon in softener slot. (fig.“C”). Select the “Rinse+Spin” programme,reduce the speed to 1000rpm and strat Refit the siphon in the detergent drawer and fit the drawer back inside its housing. DRAINING RESIDUAL WATER(depends on model) B Before emptying the residual water, switch the appliance off and unplug it C fromthe mains socket. Remove the plinth,place a container beneath it.
3 Put a flat container under filter door and then drain with emergency drain pipe (see [draining residual water] for specific operation methods). Then, loosen filter anticlockwise and completely unscrew and remove the filter. D 4 5 6 7 D Check the supply hose regularly for brittleness and cracks and replace it if necessary using a new hose of the same type(available from After-Sales Service or specialist dealer).
solv and the power switched ON remove some too 15 16
Fault Code List Hot / Cold fill fault - For Models with Dual Inlets If you wish to connect hot and cold water supply (Fig.1): 1 Fix the red marked inlet hose to the hot water tap and to the inlet valve with the red filter on the rear side of machine. 2 Fix the other inlet hose to the cold water tap and to the inlet valve with the blue filter on the rear side of the machine.
C. Fault code The washer stops when the program is running. The display window shows fault code “F24”, fault codes from “F04’ to “F07”, “F13”, “F23” or “Unb”. TRANSPORT/HANDING If fault code “F24” is shown Water level reaches overflow level. Remove it by pressing “Start/Pause” key and feed water. Select and start required program. If fault occurs again, disconnect power supply and contact with after-sale service. If fault code “F04” to “F07”, “F23” shown Electronic module fails.
