User Manual

Before plugging in you cooler for the first time remove all packaging, clean the cooler with a
soft rag and a mixture of lukewarm water and baking soda(2 tablespoons baking soda in 1
quart of water works well). Wipe dry with soft cloth.
Note: Let stand upright for at least 4 hours before plugging in, to avoid potential damage to
the compressor.
Temperature Control
RW46N1DSD
Note:The set temperature range for both upper and lower compartments is 39 deg F to 64
F (4 deg C to 18 deg C).
①.“ ”TurnWineCellarON/OFF
To turn this unit ON and OFF, press and hold this button for approximately 3 seconds.
②.“ ” Energy Saver
Energy Saver button:Pressing this button for 3 seconds will turn the energy saver mode
either ON or OFF. When the energy saver mode is ON, the LED light and display will be
turned
off, the °F / °C light will be on.
③.“ ” Set temperature lower
Each pression will lower temperature of the upper chamer 1°F(or 1°C).
④.“ ” Set temperature higher
Each pression once will increase temperature of the upper chamer 1°F(or 1°C).
⑤. LED Temperature Display
Display temperature for the upper zone.
⑥.“ ” Compressor Indicator Light
Indicates that compressor is operating.
⑦.“ °F / °C ” Indicator Light
Will change as the “ °F/ °C ” button is pressed.
⑧.LED Temperature Display
Display temperature for the lower zone.
⑨.“ ” Set temperature higher
Each pression will increase temperature of the lower chamer 1°F(or 1°C).
⑩.“ ” Set temperature lower
Each pression will lower temperature of the lower chamer 1°F(or 1°C).
⑪.“ °F/ °C ” Switch
Pressing this button switches the indicator light between °C and °F.
11
Operation
Hisense Wine Cooler