User manual

17
First use and installation
This appliance performs well from N to T.
The appliance may not work properly if it
is left for a longer period at a temperature
above or below the indicated range.
Important! It is necessary to have good
ventilation around the freezer to allow for
the dissipation of heat, high efficiency, and
low power consumption.For this reason,
sufficiently cleared space should be
available around the freezer.It is advisable
for there to be 75mm separating the back
of the freezer to the wall at least 100mm
of space on its two sides, a height of over
100mm from its top and a clear space in
front to allow the doors to open 160°.
Warning! Before installing, read the
instructions carefully for your safety
and the correct operation of the appliance.
Position the appliance away from sources
of heat such as stoves, radiators, direct
sunlight, etc.
Maximum performance and safety are
guaranteed by maintaining the correct
indoor temperature for the class of unit
concerned, as specified on the rating
plate.
Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
neutral soap in order to remove the typical
smell of a brand new product, then dry
thoroughly.
Appliances must not be exposed to rain.
Sufficient air must be allowed to circulate
in the lower rear section of the appliance,
as poor air circulation can affect perfor-
mance. Built-in appliances should be
positioned away from heat sources such
as heaters and direct sunlight.
Leveling
Electrical connection
Caution! Any electrical work required to
install this appliance should be carried out by
a qualified or person.authorized
Warning!This appliance must be grounded.
The manufacturer declines any liability should
these safety measures not be observed.
the floor. You can also adjust the level by
the appropriate level
the front (use your fingers or a suitable
spanner).
unscrewing adjustment
in
The appliance should be level in order to
eliminate vibration. To make the appliance
level, it should be upright and both
adjusters should be with in stable contact
Cleaning before use
Installation Positioning
Climate class
Ambient temperature
SN
N
ST
T
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
75mm
100mm
100mm