User`s manual

Hisense Refrigerator
7
Special flange
self-tapping screws
Earth wire
①
②
③
Upper hinge part
Note: Please hold the door by hand
during step 4 to prevent door dropping.
5. Remove the door and place it on a
smooth surface with its panel upwards.
Lever part① and part④ ,then loose
screws② , as shown in the picture.
Change handle③to the right side, then
install screws② , part① and part④ in
turn. Loose screws⑦ , detach part⑥
and part⑤,
turn part ⑥ over and then
install part⑤ and part⑥ to the left side
with screws⑦.
1
2
3
② Special self-tapping screws
③ Handle
① Handle covers
④ Screw hole covers
⑤ Door holder
⑥ Stop block
⑦ Self-tapping screws
1
2
3
4
Note 2:Install the handle cover as
the follow figure shows :button the
buckle firstly , and then close the
cover from the inside until you hear
the sound of "popping" .
Note 1:Remove the handle cover as
the follow figure shows :bend the
upper wing and take the upper
buckle apart from the handle,and so
as the other side,after that take
down the handle cover.
buckle
buckle
6. Place refrigerator flatwise, remove
part③ and then loose screws④.
Remove part ② and part①.
Note: washer may
stick to door.
washer
② Front foot fixed board
④ Self-tapping screws
③ Adjustable bottom feet part
① Lower hinge part（right）
7. Screw out lower hinge, change it to
the near hole site, and then screw up
and mount washer.
8.Just remount to the step 6,change
part①to left and part②to right and then
fix them with screws④. Finally install
part③.
Lower hinge part (left)