User`s manual

Hisense Refrigerator
6
Reversing the door
The side at which the door opens can
be changed, from the right side (as
supplied) to the left side, if the
installation site requires.
Warning! When reversing the door, the
appliance must not be connected to the
mains. Ensure that the plug is removed
from the mains socket.
Tools you will need:
8mm socket wrench
Cross-shaped screwdriver
8mm wrench
Thin-blade screwdriver
Note: Before you start lay the
refrigerator on its back in order to
gain access to the base, you should
rest it on soft foam packaging or
similar material to avoid damaging
the backboard of the refrigerator. To
reverse the door, the following steps
are generally recommended.
1. Stand the refrigerator upright.
Open the door to take out all door
racks (to avoid racks damaged) and
then close
the door.
Door racks
2. Open part ① on top of the
refrigerator body from right side and
then take down part ③ and part ④ on
the door in the same way. Take down
part ② and put it back to the plastic
bag.
1
③Upper cover of upper door
②Upper hinge cover (right)
①Upper cover
④Corner cover
3
2
3. Disconnect electrical connector① as
well as electrical connector② and then
take down part③.
3
2
1
4. Remove the screws ①, loose
wire②, and remove part③.
buckle